Testers & Meters

WT-100MT

Cable testers are designed to test for mis-wiring, continuity, and polarization.
The auto-scan funtionality compares continuity on both transmitting and
receiving ends by utilizing the terminator provided. Cables may be tested
prior to, during or after installation.

WT-33-100

This tester is used to test for 2, 3 and 4 pair voice and data channels.
Sequencing LED display provides instant indication of any shorts, opens,
reversals or miswires.

WT-205PAK

Verifies cable continuity and identifies wiring faults.
• Two position switch for single or multi-tone signal
• LEDs for line polarity, continuity and voltage
• Testing leads and modular cables for individual wire tests or modular
jack tests
• Plastic tips to prevent accidental shorts
• Trace or identify wire or cables in a bundle or group

WT-Test-PC1

The third generation of PC Cable tester. A specially designed multi-function
cable tester that tests and analyzes a comprehensive range of PC connector
types and the most commonly used flat cables. Features include:
• Identify open wires, short wires, and mis-wires connectivity
• Support 187 flat types of PC connectors
• 100 test results can be saved and transferred to PC via USB, which can
then be printed
• LCD display with back light function
• Low voltage indicator

TSTL-1

This unit is equipped with short circuit detector LED located on the head
of the transmitter section. If a DC short circuit exists in the cable the LED
will light up. Many high quality splitters used for MDU applications are short
circuits to DC. If these splitters are in the cable line, the LED will light up.